CHECK MAIN BODY ECU (FUSE BLOCK ASSEMBLY)
Disconnect the 3A, 3C and 3G main body ECU (fuse block assembly) connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 3A-1 - Body ground | B - Body ground | Battery power supply | Always | 11 to 14 V |
| 3C-16 - Body ground | P - Body ground | Battery power supply | Always | 11 to 14 V |
| 3G-1 - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 3G-11 - Body ground | W - Body ground | Ground | Always | Below 1 Ω |
| 3G-12 - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction in the wire harness.
Reconnect the 3A, 3C and 3G main body ECU (fuse block assembly) connectors.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 3I-5 - Body ground | W - Body ground | ACC power supply | Ignition switch off | Below 1 V |
| Ignition switch ACC | 11 to 14 V | |||
| 3C-6 - Body ground | B - Body ground | Ignition switch power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| 3C-3 - Body ground | BE - Body ground | Clearance light LH signal output | Headlight dimmer switch assembly (light control switch) in tail or head position | 11 to 14 V |
| Headlight dimmer switch assembly (light control switch) off | Below 1 V | |||
| 3C-4 - Body ground | L - Body ground | Clearance light RH signal output | Headlight dimmer switch assembly (light control switch) in tail or head position | 11 to 14 V |
| Headlight dimmer switch assembly (light control switch) off | Below 1 V | |||
| 3L-1 - Body ground | B - Body ground | Taillights signal output | Headlight dimmer switch assembly (light control switch) in tail or head position | 11 to 14 V |
| Headlight dimmer switch assembly (light control switch) off | Below 1 V | |||
| 3C-5 - Body ground | B-Y - Body ground*1
L-R - Body ground*2 |
Low beam headlight LH signal output | Headlight dimmer switch assembly (light control switch) in head position | 11 to 14 V |
| Headlight dimmer switch assembly (light control switch) not in head position | Below 1 V | |||
| 3C-10 - Body ground | B-R - Body ground*1
B-W - Body ground*2 |
Low beam headlight RH signal output | Headlight dimmer switch assembly (light control switch) in head position | 11 to 14 V |
| Headlight dimmer switch assembly (light control switch) not in head position | Below 1 V | |||
| 3C-11 - Body ground*3 | P-B - Body ground | Front fog light RH signal output | Headlight dimmer switch assembly (light control switch) in tail or head position, headlight dimmer switch assembly (fog light switch) in front position | 11 to 14 V |
| Headlight dimmer switch assembly (light control switch) in tail or head position, headlight dimmer switch assembly (fog light switch) off | Below 1 V | |||
| 3C-12 - Body ground*3 | R-G - Body ground | Front fog light LH signal output | Headlight dimmer switch assembly (light control switch) in tail or head position, headlight dimmer switch assembly (fog light switch) in front position | 11 to 14 V |
| Headlight dimmer switch assembly (light control switch) in tail or head position, headlight dimmer switch assembly (fog light switch) off | Below 1 V | |||
| 3C-17 - Body ground | L-W - Body ground*1
LG - Body ground*2 |
High beam headlight LH signal output | Headlight dimmer switch assembly (dimmer switch) in high or high flash position | 11 to 14 V |
| Headlight dimmer switch assembly (dimmer switch) in low position | Below 1 V | |||
| 3C-18 - Body ground | R-Y - Body ground*1
GR - Body ground*2 |
High beam headlight RH signal output | Headlight dimmer switch assembly (dimmer switch) in high or high flash position | 11 to 14 V |
| Headlight dimmer switch assembly (dimmer switch) in low position | Below 1 V | |||
| 3L-7 - Body ground | V - Body ground | Rear turn signal light RH signal output | Ignition switch ON turn signal light RH off | Below 1 V |
| Ignition switch ON turn signal light RH blinking | Below 1 V ←→ 11 to 14 V | |||
| 3L-16 - Body ground | L - Body ground | Rear turn signal light LH signal output | Ignition switch ON turn signal light LH off | Below 1 V |
| Ignition switch ON turn signal light LH blinking | Below 1 V ←→ 11 to 14 V | |||
| 3E-5 - Body ground | L - Body ground | Front turn signal light RH signal output | Ignition switch ON turn signal light RH off | Below 1 V |
| Ignition switch ON turn signal light RH blinking | Below 1 V ←→ 11 to 14 V | |||
| 3E-6 - Body ground | LG - Body ground | Front turn signal light LH signal output | Ignition switch ON turn signal light LH off | Below 1 V |
| Ignition switch ON turn signal light LH blinking | Below 1 V ←→ 11 to 14 V | |||
| 3E-5 - Body ground*4 | L - Body ground | Side turn signal light RH signal output | Ignition switch ON turn signal light RH off | Below 1 V |
| Ignition switch ON turn signal light RH blinking | Below 1 V ←→ 11 to 14 V | |||
| 3E-6 - Body ground*4 | LG - Body ground | Side turn signal light LH signal output | Ignition switch ON turn signal light LH off | Below 1 V |
| Ignition switch ON turn signal light LH blinking | Below 1 V ←→ 11 to 14 V | |||
| 3E-5 - Body ground*5 | L - Body ground | Side turn signal light RH signal output | Ignition switch ON turn signal light RH off | Below 1 V |
| Ignition switch ON turn signal light RH blinking | Below 1 V ←→ 11 to 14 V | |||
| 3E-6 - Body ground*5 | LG - Body ground | Side turn signal light LH signal output | Ignition switch ON turn signal light LH off | Below 1 V |
| Ignition switch ON turn signal light LH blinking | Below 1 V ←→ 11 to 14 V | |||
| 3E-18 - Body ground | BE - Body ground | Power source of stop light switch | Always | 11 to 14 V |
| 3E-10 - Body ground | Y - Body ground | Stop light switch signal input | Brake pedal depressed | 11 to 14 V |
| 3K-2 - Body ground | SB - Body ground | Stop light switch signal output | Brake pedal depressed | 11 to 14 V |
| 3L-13 - Body ground | LG-B - Body ground*6
GR-B - Body ground*7 |
Courtesy light switch assembly (driver door) signal input | Driver side door open | Below 1 V |
| Driver side door closed | Pulse generation (See waveform) | |||
| 3F-1 - Body ground | R - Body ground | Telltale Light Assembly (hazard warning signal switch) input | Telltale Light Assembly (hazard warning signal switch) off | Pulse generation (See waveform) |
| Telltale Light Assembly (hazard warning signal switch) on | Below 1 V |
*1: for Single Beam Headlight
*2: for Dual Beam Headlight
*3: w/ Front Fog Light
*4: for Outer Rear View Mirror Type Side Turn Signal Light
*5: for Front Fender Type Side Turn Signal Light
*6: for LHD
*7: for RHD
If the result is not as specified, the main body ECU (fuse block assembly) may be malfunctioning.
Inspect using an oscilloscope.
The waveform shown in the illustration is an example for reference only. Noise, chattering, etc. are not shown.
Waveform (Reference)
| Item | Content |
|---|---|
| Tester Connection | 3L-13 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Driver side door closed |
| Item | Content |
|---|---|
| Tester Connection | 3F-1 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Telltale Light Assembly (hazard warning signal switch) off |