Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2015.08–2016.09
RM19Y0E _59 Vehicle Exterior _003020 LIGHTING (EXT) _0015281 LIGHTING SYSTEM U

LIGHTING (EXT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Body or Combi SW / Data List.


e.

Read the Data List according to the display on the GTS or Techstream.

Body Electrical / Body / Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
IG SW(IG1)(Main) Ignition switch ON signal ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
-
Driver door courtesy SW Courtesy light switch (for driver side) signal ON or OFF ON: Driver side door open
OFF: Driver side door closed
-
ACC SW(Main) Ignition switch ACC signal ON or OFF ON: Ignition switch ACC
OFF: Ignition switch off
-
Hazard SW Hazard warning signal switch signal ON or OFF ON: Telltale light assembly (hazard warning signal switch) on
OFF: Telltale light assembly (hazard warning signal switch) off
-
Stop SW Stop light switch signal ON or OFF ON: Stop light switch on
OFF: Stop light switch off
-
Distinction of head lamp Type of headlight assembly 2 lamp ON, 4 lamp ON 2 lamp ON: Headlight assembly (for Single Beam Headlight)
4 lamp ON: Headlight assembly (for Dual Beam Headlight)
-

Body Electrical / Combi SW / Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Turn 3 blinking customize ON/OFF status of triple-blink customization ON or OFF Customize setting displayed -
Blinking permit counter Setting value for triple-blink cancellation 350ms, 750ms, 1000ms, 1500ms Customize setting displayed -



ACTIVE TEST


HINT:

Using the GTS or Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Body / Active Test.


e.

According to the display on the GTS or Techstream, perform the Active Test.

Body Electrical / Body / Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Turn lamp turn signal light operation LH ON, RH ON, RH/LH ON -
Tail lamp Taillight relay ON/OFF -
Head lamp Turns the high beam or Low beam headlights Hi ON/Lo ON -
Fr fog lamp Front fog light relay ON/OFF w/ Front Fog Light