1.INSPECT DIFFERENTIAL OIL LEVEL
Stop the vehicle on a level surface.
Remove the differential filler plug and gasket.
Check that the oil level is within 0 to 5 mm (0 to 0.197 in.) of the bottom of the filler plug opening.
Excessively large or small amounts of oil may cause problems.
If the oil level is low, add differential oil to adjust the oil level.
If the oil level is still low, check for oil leakage. If leakage is found, repair or replace the part necessary to stop the leakage.
Install the differential filler plug with a new gasket.
2.DRAIN DIFFERENTIAL OIL
Stop the vehicle on a level surface.
Remove the differential drain plug and gasket.
Drain the oil.
Install a new gasket and the differential drain plug.
3.ADD DIFFERENTIAL OIL
Remove the rear differential filler plug and gasket.
Pour oil into the rear differential carrier assembly so that the oil level is within 0 to 5 mm (0 to 0.197 in.) of the bottom of the filler plug opening.
Excessively large or small quantities of oil may cause problems.
Hypoid gear oil API grade GL-5 SAE 80W-90, 85W-90 or 90
3.7 liters (3.91 US qts, 3.26 Imp. qts)
Install the rear differential filler plug with a new gasket.
Drive the vehicle and check the oil level again. If necessary, add differential oil.