DATA LIST
Using the GTS or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Body Electrical / Body / Data List.
Read the Data List according to the display on the GTS or Techstream.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| IG SW(IG1)(Main) | Ignition switch IG signal | OFF or ON | OFF: Ignition switch off
ON: Ignition switch ON |
- |
| KEY SW | Key switch signal | OFF or ON | OFF: No key in ignition key cylinder
ON: Key inserted in ignition key cylinder |
- |
| Driver door courtesy SW | Driver side door courtesy light switch signal | OFF or ON | OFF: Driver side door closed
ON: Driver side door open |
- |
| ACC SW(Main) | Ignition switch ACC signal | OFF or ON | OFF: Ignition switch off
ON: Ignition switch ACC |
- |