Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › SFI SYSTEM(w/ Air Fuel Ratio Sensor) › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196262 SFI SYSTEM(w/ Air Fuel Ratio Sensor) C

2NR-VE ENGINE CONTROL  SFI SYSTEM(w/ Air Fuel Ratio Sensor)  P0500  Vehicle Speed Sensor Signal System  


DESCRIPTION

Based on transmission revolution sensor (output speed sensor) signals, a microcomputer in the TCM (ECM) calculates the vehicle speed.*

Based on speed sensor signals, a microcomputer in the skid control ECU (brake actuator assembly) calculates the vehicle speed. The ECM receives vehicle speed from the skid control ECU (brake actuator assembly) through the CAN communication lines.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0500 Vehicle Speed Sensor Signal System While vehicle being driven, no vehicle speed sensor signal transmitted to ECM
(2 trip detection logic)
·

CAN communication lines

·

Automatic transmission system*

·

Anti-lock brake system

·

ECM


Comes on DTC stored

*: for Automatic Transmission

WIRING DIAGRAM

A266546E05
5.281,2.677 5.781,3.021 0.5,0.344 10 false ECM 4.969,1.219 5.521,1.521 0.552,0.302 10 false CANH 1.448,1.219 2.01,1.51 0.563,0.292 10 false CANH 4.969,1.979 5.531,2.271 0.563,0.292 10 false CANL 1.469,1.969 2.073,2.281 0.604,0.313 10 false CANL 0.625,2.688 2.208,3.333 1.583,0.646 10 false Skid Control ECU (Brake Actuator Assembly) 0.792,3.438 2.625,3.75 1.833,0.313 10 false :CAN Communication Line

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS or Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0500)
a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: System Select / Health Check.


e.

Read the DTCs.

HINT:

If any DTCs other than P0500, which related to the CAN communication system, automatic transmission system or anti-lock brake system are output, troubleshoot those DTCs first.



Result:
Result Proceed to
DTC P0500 is output (for Automatic Transmission) A
DTC P0500 is output (for Manual Transmission) B
DTC P0500 and other DTCs are output C



A

B

C

GO TO DTC CHART