Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.08
RM19Y0E _55 Steering _002997 POWER ASSIST SYSTEMS _0015160 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  TERMINALS OF ECU  


CHECK POWER STEERING ECU ASSEMBLY


C329956C04
2.083,1.865 2.438,2.063 0.354,0.198 2.563,1.865 2.917,2.063 0.354,0.198 3.302,1.865 3.656,2.063 0.354,0.198 4.313,1.875 4.667,2.073 0.354,0.198 0.188,0.167 0.5,0.365 0.313,0.198 10 false *a 2.146,1.885 2.51,2.094 0.365,0.208 10 false E75 3.396,1.885 3.708,2.083 0.313,0.198 10 false z1 2.667,1.885 2.979,2.083 0.313,0.198 10 false z6 4.375,1.896 4.813,2.125 0.438,0.229 10 false E74
*a Component with harness connected
(Power Steering ECU Assembly)
- -


a.

Measure the voltage and resistance according to the value(s) in the table below.

NOTICE:
·

Check if the power steering ECU assembly connectors are securely connected by pulling on them from the backside.

·

If the EPS warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU's terminals to become 0 V.



Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E74-1 (BAT+) - Body ground B - Body ground Battery power source Always 11 to 14 V
E74-2 (GND) - Body ground W-B - Body ground Body ground Always Below 1 Ω
E75-5 (CANH) - E75-1 (CANL) SB - BR CAN BUS Ignition switch off 54 to 69 Ω
E75-8 (IG) - E74-2 (GND) LG - W-B IG power source Ignition switch ON 11 to 14 V
z1-1 (M1) - E74-2 (GND) R - W-B Power steering motor assembly
·

Ignition switch ON

·

Steering wheel turned to left


Below 1 V
·

Ignition switch ON

·

Steering wheel turned to right


11 to 14 V
z1-2 (M2) - E74-2 (GND) B - W-B Power steering motor assembly
·

Ignition switch ON

·

Steering wheel turned to left


11 to 14 V
·

Ignition switch ON

·

Steering wheel turned to right


Below 1 V
z6-1 (SUB) - z6-3 (GND) Y - B Torque sensor 2 input signal Engine running, steering wheel not turned (without load) 2.2 to 2.8 V
Engine running, steering wheel turned to right with vehicle stopped 1.0 to 2.8 V
Engine running, steering wheel turned to left with vehicle stopped 2.2 to 4.0 V
z6-3 (GND) - Body ground B - Body ground Torque sensor ground Always Below 1 Ω
z6-7 (VDD) - z6-3 (GND) R - B Torque sensor power source Ignition switch ON 4.5 to 5.5 V
z6-9 (MAIN) - z6-3 (GND) W - B Torque sensor 1 input signal Engine running, steering wheel not turned (without load) 2.2 to 2.8 V
Engine running, steering wheel turned to right with vehicle stopped 2.2 to 4.0 V
Engine running, steering wheel turned to left with vehicle stopped 1.0 to 2.8 V