Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.08
RM19Y0E _55 Steering _002997 POWER ASSIST SYSTEMS _0015160 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  FAIL-SAFE CHART  


If a problem occurs in the electronic power steering system, the EPS warning light on the combination meter comes on, and the ECU stops the steering power assist, maintains a constant amount of power assist, or reduces the amount of power assist to protect the system.

DTC No. Malfunction Fail-safe
C1511/11
C1512/12
C1513/13
C1514/14
Torque sensor malfunction Power assist stopped
C1523/23
C1524/24
Motor malfunction Power assist stopped
C1531/31
C1532/32
Power steering ECU malfunction Power assist stopped
C1533/33 Temperature sensor malfunction in power steering ECU Assist force restricted
C1534/34 EEPROM abnormal Assist force restricted
C1541/41 Vehicle speed signal Assist force restricted
C1552/52 PIG power source voltage error Power assist stopped
C1553/53 Overvoltage at IG and PIG terminals Power assist stopped
C1554/54 Power source relay malfunction Power assist stopped
C1555/55 Motor relay malfunction Power assist stopped
C1557/57 Continuous Overheat Preventive Control Power assist decrease
(not malfunction but normality)

HINT:

The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept in either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.