Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.08
RM19Y0E _55 Steering _002997 POWER ASSIST SYSTEMS _0015160 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1531/31  CPU Malfunction  C1532/32  ECU Malfunction  C1533/33  Temperature Sensor Malfunction  C1534/34  EEPROM Error  


DESCRIPTION

The fail-safe function operates to stop the power assist when DTCs indicating ECU malfunctions are stored. However, when it is DTC C1533 or C1534 that has been stored, power assist continues.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1531/31 CPU Malfunction ECU internal malfunction (CPU malfunction) Power steering ECU assembly Comes on (Red) Ignition switch ON again Buzzer :
Sounds in termittently
C1532/32 ECU Malfunction ECU internal malfunction or motor circuit malfunction Power steering ECU assembly Comes on (Red) Ignition switch ON again or after system confirmed to be normal Buzzer :
Sounds in termittently
C1533/33 Temperature Sensor Malfunction ECU internal malfunction (Substrate temperature sensor malfunction) Power steering ECU assembly Comes on (Red) Ignition switch ON again or after system confirmed to be normal Buzzer :
Sounds in termittently
C1534/34 EEPROM Error ECU internal malfunction (EEPROM error) Power steering ECU assembly The warning light does not illuminate (normal reset) Ignition switch ON again -

PROCEDURE

1.CONFIRM DTC
a.

Clear the DTCs.

Chassis > EPS > Clear DTCs
50002 581

b.

Check for DTCs.

Chassis > EPS > Trouble Codes
50001 581
OK:

DTCs other than C1531/31, C1532/32, C1533/33, and C1534/34 are not output.


Result:
Proceed to
OK
NG




OK

REPLACE POWER STEERING ECU ASSEMBLY

NG