Home › Drivetrain › A4R AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM › from 2015.08
RM19Y0E _52 Drivetrain _041457 A4R AUTOMATIC TRANSMISSION / TRANSAXLE _0192556 AUTOMATIC TRANSMISSION SYSTEM D

A4R AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  MANUAL SHIFTING TEST  


PERFORM MANUAL SHIFTING TEST


HINT:
·

This test can be used to determine whether the trouble is occurring in the electrical circuit or is a mechanical problem in the transmission.

·

If any abnormalities are found in the following test, the problem is in the transmission itself.



a.

Disconnect the transmission wire connector.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the transmission wire. In this way, it is possible to change gear positions mechanically by using the shift lever.



b.

Drive with the transmission wire disconnected. Shift the shift lever into each position to check whether the gear position changes as shown in the table below.

Shift Position Shifting Condition
D 3rd
3 3rd
2 3rd
L 3rd
R Reverse
P Pawl Lock


c.

Connect the transmission wire connector.


d.

Clear the DTC.

Powertrain > A/T > Clear DTCs
50002 565