Home › Drivetrain › A4R AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM › from 2015.08
RM19Y0E _52 Drivetrain _041457 A4R AUTOMATIC TRANSMISSION / TRANSAXLE _0192556 AUTOMATIC TRANSMISSION SYSTEM D

A4R AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  INITIALIZATION  


RESET MEMORY (using GTS or Techstream)


NOTICE:

Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission assembly or valve body.


HINT:

The ECM stores the conditions that the ECT controls the automatic transmission assembly in accordance with those characteristics. Therefore, when the automatic transmission assembly, valve body, ECM or engine assembly is replaced, it is necessary to reset the memory so that the ECM can store the new information.

The reset procedure is as follows.


a.

Turn the ignition switch off.


b.

Connect the GTS or Techstream to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS or Techstream on.


e.

Perform the reset memory procedure from the main menu.


f.

Enter the following menus: Powertrain / A/T / Utility / Reset Memory.

Powertrain > A/T > Utility
Tester Display
Reset Memory
50005 565 106
CAUTION:

After performing the RESET MEMORY, be sure to perform the ROAD TEST as described earlier.

Click hereDrivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>ROAD TEST


HINT:

The ECM stores learned values by performing the ROAD TEST.




RESET MEMORY (without using GTS or Techstream)


F100115C02
1.594,0.333 1.594,0.781 true 1.823,1.469 1.823,1.823 true 1.531,0.052 1.854,0.365 0.323,0.313 10 false E 1.583,1.823 2.24,2.177 0.656,0.354 10 false ECUT 0.083,0.094 0.396,0.25 0.313,0.156 10 false *1
*1 DLC3


a.

Using SST, connect terminals 13 (ECUT) and 4 (E) of the DLC3.

SST
09843-18040  


b.

Depress the brake pedal within 3 seconds after turning the ignition switch to ON (do not start the engine) and keep depressing the pedal until procedures (*1) and (*2) are completed.


c.

Shift the shift lever P → R → P within 1 second. (The operation of P → R → P must be performed within 1 second) (*1)


d.

Repeat procedure (*1) above 8 times. (*2)

HINT:

When deletion of the learning value is completed, the AT indicator light blinks for 2.5 seconds to inform the driver about the completion.



e.

Turn the ignition switch off and turn the ignition switch to ON again.

CAUTION:

After performing the RESET MEMORY, be sure to perform the ROAD TEST as described earlier.

Click hereDrivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>ROAD TEST


HINT:

The ECM stores learned values by performing the ROAD TEST.