DATA LIST
Using the GTS or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Body Electrical / Body / Data List.
Read the Data List according to the display on the GTS or Techstream.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| IG SW(IG1)(Main) | Ignition switch IG signal | OFF or ON | OFF: Ignition switch off
ON: Ignition switch ON |
- |
| KEY SW | Key switch signal | OFF or ON | OFF: No key in ignition key cylinder
ON: Key inserted in ignition key cylinder |
- |
| Lock SW | Driver side door lock position signal | OFF or ON | OFF: Driver side door unlocked
ON: Driver side door locked |
- |
| Unlock SW | Driver side door unlock position signal | OFF or ON | OFF: Driver side door locked
ON: Driver side door unlocked |
- |
| Driver door courtesy SW | Driver side door courtesy light switch signal | OFF or ON | OFF: Driver side door closed
ON: Driver side door open |
- |
| Back door courtesy SW | Back door courtesy light switch signal | OFF or ON | OFF: Back door closed
ON: Back door open |
- |
| ACC SW(Main) | Ignition switch ACC signal | OFF or ON | OFF: Ignition switch off
ON: Ignition switch ACC |
- |
| RH rear courtesy SW* | Rear RH side door courtesy light switch signal | OFF or ON | OFF: Rear RH side door closed
ON: Rear RH side door open |
- |
| LH rear courtesy SW* | Rear LH side door courtesy light switch signal | OFF or ON | OFF: Rear LH side door closed
ON: Rear LH side door open |
- |
| Passenger courtesy SW | Front passenger side door courtesy light switch signal | OFF or ON | OFF: Front passenger side door closed
ON: Front passenger side door open |
- |
*: w/ Rear Door Courtesy Light Switch
ACTIVE TEST
Using the GTS or Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Body Electrical / Body / Active Test.
Perform the Active Test according to the display on the GTS or Techstream.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Door lock motor | Door lock motor | Unlock/Lock/Reverse | - |