CHECK MAIN BODY ECU (FUSE BLOCK ASSEMBLY)
Disconnect the 3A, 3C and 3G main body ECU (fuse block assembly) connectors.
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connectors disconnected.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 3A-1 - Body ground | B - Body ground | Battery power supply | Always | 11 to 14 V |
| 3C-16 - Body ground | P - Body ground | Battery power supply | Always | 11 to 14 V |
| 3G-1 - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 3G-11 - Body ground | W - Body ground | Ground | Always | Below 1 Ω |
| 3G-12 - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction in the wire harness.
Reconnect the 3A, 3C and 3G main body ECU (fuse block assembly) connectors.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 3I-5 - Body ground | W - Body ground | ACC power supply | Ignition switch off | Below 1 V |
| Ignition switch ACC | 11 to 14 V | |||
| 3C-6 - Body ground | B - Body ground | Ignition power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| 3D-6 - Body ground | L-R - Body ground | Engine hood courtesy switch input | Engine hood open | Below 1 V |
| Engine hood closed | Pulse generation (See waveform) | |||
| 3F-1 - Body ground | R - Body ground | Hazard warning switch signal output | Telltale light assembly (hazard warning signal switch) off | Pulse generation (See waveform) |
| Telltale light assembly (hazard warning signal switch) on | Below 1 V | |||
| 3G-15 - Body ground | G - Body ground | Unlock warning switch input | No key in ignition key cylinder | Below 1 V |
| Key inserted into ignition key cylinder | 11 to 14 V | |||
| 3L-13 - Body ground | LG-B - Body ground*1
GR-B - Body ground*2 |
Door courtesy switch (driver side) input | Driver side door open | Below 1 V |
| Driver side door closed | Pulse generation (See waveform) | |||
| 3L-6 - Body ground*3 | GR - Body ground | Door courtesy switch (Rear RH side) input | Rear RH side door open | Below 1 V |
| Rear RH side door closed | Pulse generation (See waveform) | |||
| 3L-14 - Body ground | GR-B - Body ground*1
LG-B - Body ground*2 |
Door courtesy switch (front passenger side) input | Front passenger side door open | Below 1 V |
| Front passenger side door closed | Pulse generation (See waveform) | |||
| 3K-6 - Body ground*3 | B - Body ground | Door courtesy switch (Rear LH side) input | Rear LH side door open | Below 1 V |
| Rear LH side door closed | Pulse generation (See waveform) | |||
| 3K-5 - Body ground | W - Body ground | Door courtesy switch (back door) input | Back door open | Below 1 V |
| Back door closed | Pulse generation (See waveform) | |||
| 3G-13 - Body ground | B - Body ground | Driver side door key-linked switch lock input | Driver side door key cylinder in neutral position | Pulse generation (See waveform) |
| Driver side door key cylinder in lock position | Below 1 V | |||
| 3G-14 - Body ground | L - Body ground | Driver side door key-linked switch unlock input | Driver side door key cylinder in neutral position | Pulse generation (See waveform) |
| Driver side door key cylinder in unlock position | Below 1 V | |||
| 3E-1 - Body ground*1
3E-11 - Body ground*2 |
P - Body ground*1
W - Body ground*2 |
Driver side door lock motor lock drive output | Driver side door key cylinder in neutral position | Below 1 V |
| Driver side door key cylinder in lock position | 11 to 14 V → Below 1 V | |||
| 3E-2 - Body ground*1
3E-12 - Body ground*2 |
G - Body ground*1
SB - Body ground*2 |
Driver side door lock motor unlock drive output | Driver side door key cylinder in neutral position | Below 1 V |
| Driver side door key cylinder in unlock position | 11 to 14 V → Below 1 V | |||
| 3E-11 - Body ground*1
3E-1 - Body ground*2 |
W - Body ground*1
B - Body ground*2 |
Front passenger side door lock motor lock drive output | Driver side door key cylinder in neutral position | Below 1 V |
| Driver side door key cylinder in lock position | 11 to 14 V → Below 1 V | |||
| 3E-12 - Body ground*1
3E-2 - Body ground*2 |
SB - Body ground*1
G - Body ground*2 |
Front passenger side door lock motor unlock drive output | Driver side door key cylinder in neutral position | Below 1 V |
| Driver side door key cylinder in unlock position | 11 to 14 V → Below 1 V | |||
| 3L-12 - Body ground | G - Body ground | Rear RH side door lock motor lock drive output | Driver side door key cylinder in neutral position | Below 1 V |
| Driver side door key cylinder in lock position | 11 to 14 V → Below 1 V | |||
| 3K-11 - Body ground | Y - Body ground | Rear RH side door lock motor unlock drive output | Driver side door key cylinder in neutral position | Below 1 V |
| Driver side door key cylinder in unlock position | 11 to 14 V → Below 1 V | |||
| 3L-11 - Body ground | P - Body ground | Rear LH side and back door lock motor lock drive output | Driver side door key cylinder in neutral position | Below 1 V |
| Driver side door key cylinder in lock position | 11 to 14 V → Below 1 V | |||
| 3K-12 - Body ground | BE - Body ground | Rear LH side and back door lock motor unlock drive output | Driver side door key cylinder in neutral position | Below 1 V |
| Driver side door key cylinder in unlock position | 11 to 14 V → Below 1 V |
If the result is not as specified, the main body ECU (fuse block assembly) may be malfunctioning.
*1: for LHD
*2: for RHD
*3: w/ Rear Door Courtesy Light Switch
Inspect using an oscilloscope.
The waveform shown in the illustration is an example for reference only. Noise, chattering, etc. are not shown.
Waveform (Reference)
| Item | Content |
|---|---|
| Tester Connection | 3D-6 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Engine hood closed |
| Item | Content |
|---|---|
| Tester Connection | 3F-1 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Telltale light assembly (hazard warning signal switch) off |
| Item | Content |
|---|---|
| Tester Connection | 3L-13 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Driver side door closed |
| Item | Content |
|---|---|
| Tester Connection | 3L-6 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Front passenger side door closed |
| Item | Content |
|---|---|
| Tester Connection | 3L-14 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Rear RH side door closed |
| Item | Content |
|---|---|
| Tester Connection | 3K-6 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Rear LH side door closed |
| Item | Content |
|---|---|
| Tester Connection | 3K-5 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Back door closed |
| Item | Content |
|---|---|
| Tester Connection | 3G-13 - Body ground
3G-14 - Body ground |
| Tool Setting | 5 V/DIV., 10 ms./DIV. |
| Condition | Driver side door key cylinder in neutral position |