84540
1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Install the park/neutral position switch assembly to the control shaft.
Temporarily install the bolt.
Temporarily install the transmission control shaft lever.
| *1 | Transmission Control Shaft Lever |
Turn the transmission control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
Remove the transmission control shaft lever.
| *1 | Notch |
| *a | Neutral Basic Line |
Place a ruler tightly against the notch on the control shaft, and adjust the park/neutral position switch assembly until the neutral basic line becomes parallel with the ruler.
Hold the switch in position and tighten the bolt.
Connect the connector to the park/neutral position switch assembly.
35507E
2.INSTALL TRANSMISSION CONTROL SHAFT LEVER
Install the transmission control shaft lever and nut.
33820B
3.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Set the transmission control shift lever to the N position.
Temporarily install the transmission control cable assembly to the transmission control shaft lever with the bolt.
Install the transmission control cable assembly with the white paint marks facing up to prevent the inner cable from becoming twisted.
Connect the transmission control cable assembly to the control cable bracket with a new clip.
While holding the shift lever lightly toward the R position side, tighten the bolt.
4.INSPECT SHIFT LEVER POSITION
84540
5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
51443
6.INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)