51443
1.REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)
33820B
2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the bolt and disconnect the transmission control cable assembly.
Do not excessively bend the flexible sections at the ends of the transmission control cable assembly.
Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.
35507E
3.REMOVE TRANSMISSION CONTROL SHAFT LEVER
Move the shift lever to N.
| *1 | Transmission Control Shaft Lever |
Remove the nut and transmission control shaft lever.
84540
4.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Disconnect the connector.
Remove the bolt and pull out the park/neutral position switch assembly.
Make sure that the manual valve lever sub-assembly has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever sub-assembly.