Home › Drivetrain › A4R AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE › from 2015.08
RM19Y0E _52 Drivetrain _041457 A4R AUTOMATIC TRANSMISSION / TRANSAXLE _0197966 TRANSMISSION CONTROL CABLE A

A4R AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  INSTALLATION  


PROCEDURE

Hide 33820B 1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C153890C03
2.333,0.615 2.823,0.646 true 2.854,0.563 3.292,0.99 0.438,0.427 10 *1
*1 Transmission Control Shaft Lever


Turn the transmission control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.


c.

Temporarily install the transmission control cable assembly to the transmission control shaft lever sub-assembly with the bolt.

NOTICE:

Install the transmission control cable assembly with the white paint marks facing up to prevent the inner cable from becoming twisted.



d.

Connect the transmission control cable assembly to the transmission control cable assembly bracket with a new clip.


e.
C155554N01
0.406,1.281 0.906,1.698 0.5,0.417 10 A

Install the 2 clips, and connect the transmission control cable assembly to the transmission floor shift assembly.

NOTICE:

Install a new clip at position A.



f.

Install the transmission control cable assembly onto the cable clamp.


g.

While holding the shift lever lightly toward the R position side, tighten the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


Hide 51443 3.INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)