35301A
1.INSTALL FRONT OIL PUMP OIL SEAL
Using SST and a hammer, gently tap in a new front oil pump oil seal.
When properly installed, the oil seal should be flush with the bottom of the front oil pump oil seal indentation on the front oil pump body assembly.
Be careful not to damage the front oil pump oil seal.
35617
2.INSTALL CLUTCH DRUM OIL SEAL RING
Coat 3 new clutch drum oil seal rings with Toyota Genuine ATF Type T-IV and install them on the stator shaft back side.
Do not over-expand the ring ends.
After installing the oil seal rings, check that they move smoothly.
35301B
3.INSTALL FRONT OIL PUMP BODY O-RING
Coat a new front oil pump body O-ring with Toyota Genuine ATF Type T-IV, and install it onto the front oil pump body assembly.