33335
1.INSPECT 1ST GEAR THRUST CLEARANCE
| *1 | 1st Gear |
| *2 | 2nd Gear |
Using a feeler gauge, measure the 1st gear thrust clearance.
0.10 to 0.56 mm (0.0039 to 0.0220 in.)
0.56 mm (0.0220 in.)
If the clearance exceeds the maximum, disassemble and inspect the counter gear.
33332
2.INSPECT 2ND GEAR THRUST CLEARANCE
Using a feeler gauge, measure the 2nd gear thrust clearance.
0.10 to 0.44 mm (0.0039 to 0.0173 in.)
0.44 mm (0.0173 in.)
If the clearance exceeds the maximum, disassemble and inspect the counter gear.
33335
3.REMOVE 1ST GEAR
Using 2 screwdrivers and a hammer, remove the snap ring.
Use a piece of cloth to prevent the snap ring from flying off.
Use SST, remove the radial ball bearing, 1st gear thrust washer, 1st gear and No. 2 synchronizer ring.
Remove the needle roller bearing.
Using SST, a vise and a snap expander, remove the snap ring, conical spring washer and 1st sub-gear.
33332
4.REMOVE 2ND GEAR
Using 2 screwdrivers and a hammer, remove the snap ring.
Use a piece of cloth to prevent the snap ring from flying off.
Using SST and a press, remove the No. 1 synchronizer hub assembly, No. 2 synchronizer ring set and 2nd gear.
Remove the split type needle roller bearing.
Do not widen the opening of the split type needle roller bearing 36 mm (1.42 in.) or more.
Using SST, a vise and a snap ring expander, remove the snap ring, conical spring washer and 2nd sub-gear.
33321V
5.REMOVE OUTPUT SHAFT CENTER BEARING
Using SST and a press, remove the output shaft center bearing.
33360
6.REMOVE NO. 1 SYNCHRONIZER HUB ASSEMBLY
Using a screwdriver, remove the 2 synchromesh shifting key springs.
Remove the No. 1 hub sleeve and 3 synchromesh shifting keys.