Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the RHD vehicle.
85310C
1.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for Front Side)
This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar sub-assembly.
With the windshield washer motor and pump assembly installed to the windshield washer jar sub-assembly, pour windshield washer fluid into the windshield washer jar sub-assembly.
| *a | Component without harness connected (Windshield Washer Motor and Pump Assembly) |
Check that the windshield washer fluid is pumped when battery voltage is applied to the terminals.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2 |
Washer fluid is pumped to front side |
If the result is not as specified, replace the windshield washer motor and pump assembly.
85310C
2.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for Rear Side)
This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar sub-assembly.
| *a | Component without harness connected (Windshield Washer Motor and Pump Assembly) |
With the windshield washer motor and pump assembly installed to the windshield washer jar sub-assembly, pour windshield washer fluid into the windshield washer jar sub-assembly.
Check that the windshield washer fluid is pumped when battery voltage is applied to the terminals.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1 |
Washer fluid is pumped to rear side |
If the result is not as specified, replace the windshield washer motor and pump assembly.