Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › from 2015.08
RM19Y0E _58 Vehicle Interior _003006 THEFT DETERRENT / KEYLESS ENTRY _0015195 THEFT DETERRENT SYSTEM W

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE THEFT DETERRENT SYSTEM


HINT:

The following items can be customized.


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



a.

Customizing with the GTS or Techstream

i.

Connect the GTS or Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS or Techstream on.


iv.

Enter the following menus: Customize Setting / Security.


v.

Select the setting by referring to the table below.

Tester Display Description Default Setting ECU Note
Security mode Security control OFF setting and vehicle horn sound setting ON 00:OFF,01:Mode1,10:Mode2 Main body ECU (Fuse Block Assembly)
HINT:
·

OFF: Security control is deactivated.

·

Mode1: Vehicle horn will not sound when alarm function is operating.

·

Mode2: Vehicle horn will sound when alarm function is operating.







CUSTOMIZE INTRUSION SENSOR (w/ Theft Warning ECU Assembly)


HINT:

The term "doors" used in the text refers to the driver side door, front passenger side door, rear RH side door, rear LH side door and back door.


a.

Intrusion sensor customize

i.

By performing the following procedures, the function of the intrusion sensor can be set to the disabled state.


ii.

Disabling the intrusion sensor:

1.

With the ignition switch off and the key removed from the ignition key cylinder, set the theft deterrent system in the disarmed state.

2.

With all the doors closed, open any door.

3.

Within 5 seconds after completing the above step, lock and unlock the doors more than 3 times.



iii.

Setting the intrusion sensor back to the enabled state:

·

The state of the intrusion sensor changes from disabled to enabled when any of the following conditions is met.

1.

A key is inserted into the ignition key cylinder.

2.

The ignition switch is turned to ON.

3.

A wireless unlock signal is received.

4.

After the intrusion sensor was set to disabled state, the theft deterrent system has not been set for 5 minutes.