There is danger of explosion if the battery is incorrectly replaced. Replace the battery only with the same or equivalent type.
Do not expose the battery to excessive heat such as sunshine, fire or equivalent.
89751A
1.REMOVE TRANSMITTER HOUSING COVER
89071B
2.REMOVE DOOR CONTROL TRANSMITTER SUB-ASSEMBLY
3.REMOVE TRANSMITTER BATTERY
Remove the battery cap.
| *1 | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the transmitter battery.
Do not push the terminals with your finger.
Do not forcibly pry up the transmitter battery as the terminals may be damaged.
Do not touch or move any components inside the transmitter. It may interfere with proper operation.
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.
4.INSTALL TRANSMITTER BATTERY
Install the battery.
Do not bend the transmitter battery electrode during installation.
Keep the inside of the transmitter housing cover free of dust and oil.
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.
Install the battery cap.
89071B
5.INSTALL DOOR CONTROL TRANSMITTER SUB-ASSEMBLY
89751A
6.INSTALL TRANSMITTER HOUSING COVER