1.REMOVE GENERATOR PULLEY
| *a | Hold |
| *b | Turn |
Secure the generator drive end frame in a vise between aluminum plates.
Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise with the specified torque.
| Item | Part No. |
|---|---|
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06021 |
Check that SST is securely fitted onto the generator rotor shaft.
Insert SST2, and engage SST2 to the generator pulley nut.
| *a | Hold |
| *b | Turn |
To loosen the generator pulley nut, turn SST1-A in the direction shown in the illustration.
To prevent damage to the rotor shaft, do not loosen the generator pulley nut by more than one half turn.
Remove SST2 from the generator assembly.
| *a | Hold |
| *b | Turn |
Hold SST1-A, Turn SST1-B, and remove SST1-A and SST1-B in the direction shown in the illustration.
Remove the generator pulley nut and generator pulley.
Remove the generator assembly from a vise.
2.REMOVE GENERATOR REAR END COVER
Remove the 3 bolts and generator rear end cover.
3.REMOVE TERMINAL INSULATOR
Remove the terminal insulator.
27370
4.REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
Remove the 2 screws and generator brush holder assembly.
27360
5.REMOVE GENERATOR COIL ASSEMBLY
Remove the 4 bolts.
| *a | Hold |
| *b | Turn |
Using SST, remove the generator coil assembly.
Remove the bearing cover packing.
If the bearing cover packing breaks, remove broken pieces completely.
The bearing cover packing may be installed on the generator rotor assembly.
27330
6.REMOVE GENERATOR ROTOR ASSEMBLY
Remove the generator rotor assembly.
Do not drop the generator rotor assembly.
27310B
7.INSPECT GENERATOR DRIVE END FRAME BEARING
Check that the generator drive end frame bearing is not rough or worn.
If necessary, replace the generator drive end frame bearing.
27310B
8.REMOVE GENERATOR DRIVE END FRAME BEARING
Remove the 4 screws and retainer plate.
Using SST and a hammer, tap out the generator drive end frame bearing.