Home › Power Source / Network › 2NR-VE BATTERY / CHARGING › GENERATOR › from 2015.08
RM19Y0E _57 Power Source / Network _041459 2NR-VE BATTERY / CHARGING _0192574 GENERATOR G

2NR-VE BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A118443C02
1.031,0.469 0.813,0.698 false 1.042,0.333 1.552,0.823 0.51,0.49 10 *a
*a Length


Using a vernier caliper, measure the brush length.

Standard length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum length:

4.5 mm (0.177 in.)


If the brush length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A153720C06
1.906,1.115 2.167,0.563 2.167,0.563 1.76,1.042 false 2.208,0.5 2.458,0.667 0.25,0.167 10 *a
*a Slip Ring


Check the generator rotor assembly for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.85 to 2.25 Ω


If the result is not as specified, replace the generator rotor assembly.



b.
A153814C04
2,1.375 2.552,0.792 false 1.563,0.615 2,0.188 false 2.021,0.115 2.333,0.271 0.313,0.156 10 *a 2.594,0.719 2.906,0.875 0.313,0.156 10 *b
*a Rotor Core
*b Slip Ring


Check the generator rotor assembly for a short to ground.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor core Always 1 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



c.
A158899

Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.

If the bearing does not rotate smoothly, replace the generator rotor assembly.


d.
A182587C04
0.552,0.596 0.712,0.748 0.16,0.152 10 *a
*a Diameter


Using a vernier caliper, measure the slip ring diameter.

Standard Diameter:

14.2 to 14.4 mm (0.559 to 0.567 in.)


Minimum Diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.


e.
A235337

Check that the slip rings are not rough or scored.

If rough or scored, replace the generator rotor assembly.


Hide 3.INSPECT GENERATOR DRIVE END FRAME BEARING

a.
A153387

Check that the generator drive end frame bearing is not rough or worn and that it rotates smoothly.

If rough, worn or does not rotate smoothly, replace the generator drive end frame bearing.