Home › Power Source / Network › 2NR-VE BATTERY / CHARGING › BATTERY CURRENT SENSOR › from 2015.08
RM19Y0E _57 Power Source / Network _041459 2NR-VE BATTERY / CHARGING _0212102 BATTERY CURRENT SENSOR A

2NR-VE BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 28850 2.REMOVE BATTERY CURRENT SENSOR ASSEMBLY

a.
A359554

Disconnect the connector.


b.

Disengage the clamp to remove the battery current sensor assembly.


c.
E234674

Pull out the battery current sensor assembly from the negative (-) battery terminal.