Home › General › SPECIFICATIONS › 1NR-VE ENGINE CONTROL › from 2015.08
RM19Y0E _V1 General _002965 SPECIFICATIONS _0193136 1NR-VE ENGINE CONTROL F

SPECIFICATIONS  1NR-VE ENGINE CONTROL  SERVICE DATA  


Spark Plug
Standard Insulation Resistance Spark plug (terminal part) - Ground 10 MΩ or higher
Spark Plug Type DENSO made SC16HR11
Maximum Electrode Gap for Used Spark Plug 1.3 mm (0.0512 in.)
Standard Electrode Gap for New Spark Plug 1.0 to 1.1 mm (0.0394 to 0.0433 in.)

Camshaft Timing Oil Control Valve Assembly
Standard Resistance 20°C (68°F) 6.9 to 7.9 Ω

Throttle Body with Motor Assembly
Standard Resistance 1 (M-) - 2 (M+) 25°C (77°F) 1.28 to 1.48 Ω

Intake Air Flow Meter Assembly
Standard Resistance 1 (THA) - 2 (E2) -20°C (4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
80°C (176°F) 0.49 to 0.67 kΩ

Engine Coolant Temperature Sensor
Standard Resistance 1 - 2 20°C (68°F) 2.32 to 2.59 kΩ
80°C (176°F) 0.310 to 0.326 kΩ

Knock Control Sensor
Standard Resistance 20°C (68°F) 120 to 280 kΩ

Oxygen Sensor
Standard Resistance 1 (HT1B) - 2 (+B) 20°C (68°F) 11.7 to 15.5 Ω
1 (HT1B) - 4 (E2) Always 10 kΩ or higher

No. 1 Integration Relay (E-THRO relay)
Standard Resistance 1F-2 - 1F-9 Battery voltage is not applied to terminals 1J-3 or 1F-10 and 1F-7 10 kΩ or higher
Battery voltage is applied to terminals 1J-3 or 1F-10 and 1F-7 Below 1 Ω

No. 1 Integration Relay (EFI-MAIN relay)
Standard Resistance 1F-10 - 1F-17 Battery voltage is not applied to terminals 1F-5 and 1F-17 10 kΩ or higher
1J-3 - 1F-17
1F-10 - 1F-17 Battery voltage is applied to terminals 1F-5 and 1F-17 Below 1 Ω
1J-3 - 1F-17

No. 1 Integration Relay (MGC relay)
Standard Resistance 1D-7 - 1D-8 Battery voltage is not applied to terminals 1D-9 or 1D-10 and 1D-2 10 kΩ or higher
Battery voltage is applied to terminals 1D-9 or 1D-10 and 1D-2 Below 1 Ω

No. 1 Integration Relay (IG1 relay)
Standard Resistance 1D-9 - 1E-5 Battery voltage is not applied to terminals 1D-1 and 1F-18 10 kΩ or higher
1D-10 - 1E-5
1D-9 - 1E-5 Battery voltage is applied to terminals 1D-1 and 1F-18 Below 1 Ω
1D-10 - 1E-5

No. 1 Integration Relay (IG2 relay)
Standard Resistance 1D-5 - 1E-5 Battery voltage is not applied to terminals 1D-1 and 1F-18 10 kΩ or higher
Battery voltage is applied to terminals 1D-1 and 1F-18 Below 1 Ω

No. 1 Integration Relay (RAD/FAN NO. 1 relay)
Standard Resistance 1E-1 - 1E-4 Battery voltage is not applied to terminals 1D-5 and 1D-6 10 kΩ or higher
Battery voltage is applied to terminals 1D-5 and 1D-6 Below 1 Ω

No. 1 Integration Relay (RAD/FAN NO. 2 relay)
Standard Resistance 1E-3 - 1E-4 Battery voltage is not applied to terminals 1D-5 and 1D-12 10 kΩ or higher
Battery voltage is applied to terminals 1D-5 and 1D-12 Below 1 Ω

No. 1 Integration Relay (Fuel pump relay)
Standard Resistance 1D-3 - 1D-11 Battery voltage is not applied to terminals 1D-4 and 1D-5 10 kΩ or higher
Battery voltage is applied to terminals 1D-4 and 1D-5 Below 1 Ω

No. 1 Integration Relay (ST NO. 2 relay circuit)
Standard Resistance 1E-6 - 3 Always Below 1 Ω
1F-1 - 5 Always Below 1 Ω
1F-13 - 2 Always Below 1 Ω
1F-14 - 2 Always Below 1 Ω
1F-15 -1 Always Below 1 Ω
1F-16 -1 Always Below 1 Ω
1J-4 - 5 Always Below 1 Ω