Home › General › SPECIFICATIONS › CLUTCH › from 2015.08
RM19Y0E _V1 General _002965 SPECIFICATIONS _0014943 CLUTCH F

SPECIFICATIONS  CLUTCH  SERVICE DATA  


Pedal height from floor panel (for 1NR-VE) - 167.9 mm (6.610 in.)
Pedal height from floor carpet (for 1NR-VE) - 150.0 mm (5.910 in.)
Pedal height from floor panel (for 2NR-VE) - 164.1 mm (6.461 in.)
Pedal height from floor carpet (for 2NR-VE) - 142.0 mm (5.590 in.)
Pedal free play (for 1NR-VE) - 15 to 25 mm (0.591 to 0.984 in.)
Pedal free play (for 2NR-VE) - 3.0 to 20.0 mm (0.118 to 0.787 in.)
Push rod play at pedal top (for 2NR-VE) - 1.0 to 8.0 mm (0.039 to 0.315 in.)
Clutch release point from pedal full stroke end position (for 1NR-VE) - 25 mm (0.984 in.) or more
Pedal stroke (for 1NR-VE) - 150 mm (5.905 in.)
Clutch release point from pedal full stroke end position (for 2NR-VE) - 25 mm (0.984 in.) or more
Pedal stroke (for 2NR-VE) - 142.5 mm (5.610 in.)
Clutch disc rivet depth (for 1NR-VE) - 0.4 mm (0.016 in.)
Clutch disc rivet depth (for 2NR-VE) - 0.4 mm (0.016 in.)
Clutch disc runout (for 1NR-VE) - 1.0 mm (0.039 in.)
Clutch disc runout (for 2NR-VE) - 1.0 mm (0.039 in.)
Diaphragm spring (for 1NR-VE) Maximum depth
Maximum width
0.5 mm (0.020 in.)
6.0 mm (0.236 in.)
Diaphragm spring (for 2NR-VE) Maximum depth
Maximum width
0.5 mm (0.020 in.)
6.0 mm (0.236 in.)
Flywheel runout (for 1NR-VE) Maximum 0.1 mm (0.004 in.)
Flywheel runout (for 2NR-VE) Maximum 0.1 mm (0.004 in.)
Diaphragm spring tip non-alignment (for 1NR-VE) Maximum non-alignment 0.5 mm (0.020 in.)
Diaphragm spring tip non-alignment (for 2NR-VE) Maximum non-alignment 0.5 mm (0.020 in.)
Clutch start switch assembly resistance OFF (Shaft not depressed)
ON (Shaft depressed)
Below 1 Ω
10 kΩ or higher

LUBRICANT
Item Capacity Classification
Brake fluid - SAE J1703 or FMVSS No. 116 DOT3