TERMINALS OF ECU
| *a | Component without harness connected
(Skid Control ECU (Brake Actuator Assembly)) |
- | - |
| Terminal No. (Symbol) | Terminal Description |
|---|---|
| 1 (GND2) | Pump motor ground |
| 10 (CANL) | CAN communication low line |
| 12 (+IG) | ECU power supply |
| 13 (+BM) | Motor relay power supply |
| 15 (RR0) | Rear wheel speed RH (-) signal input |
| 16 (RR1) | Rear wheel speed RH (+) signal input |
| 17 (FL0) | Front wheel speed LH (-) signal input |
| 18 (FL1) | Front wheel speed LH (+) signal input |
| 22 (CANH) | CAN communication high line |
| 25 (GND1) | Skid control ECU ground |
| 28 (RL0) | Rear wheel speed LH (-) signal input |
| 29 (RL1) | Rear wheel speed LH (+) signal input |
| 30 (FR0) | Front wheel speed RH (-) signal input |
| 31 (FR1) | Front wheel speed RH (+) signal input |
| 35 (STP) | Stop light switch input |
| 38 (+BS) | Solenoid relay power supply |
TERMINAL INSPECTION
Disconnect the connector and measure the voltage or resistance on the wire harness side.
| *a | Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly)) |
- | - |
The voltage cannot be measured with the connector connected to the skid control ECU (brake actuator assembly) as the connector is watertight.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| A13-1 (GND2) - Body ground | W-B - Body ground | Pump motor ground | Always | Below 1 Ω |
| A13-10 (CANL) - Body ground | G - Body ground | CAN bus | Ignition switch off | 200 Ω or more |
| A13-12 (+IG) - Body ground | L - Body ground | ECU power supply | Ignition switch ON | 11 to 14 V |
| A13-13 (+BM) - Body ground | R - Body ground | Motor relay power supply | Always | 11 to 14 V |
| A13-22 (CANH) - Body ground | R - Body ground | CAN bus | Ignition switch off | 200 Ω or more |
| A13-25 (GND1) - Body ground | BR - Body ground | Skid control ECU ground | Always | Below 1 Ω |
| A13-35 (STP) - Body ground | BE - Body ground | Stop light switch input | Brake pedal depressed → released | 6 to 14 V → Below 2 V |
| A13-38 (+BS) - Body ground | P - Body ground | Solenoid relay power supply | Always | 11 to 14 V |