Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.09
RM19Y0E _53 Suspension _059025 TIRE PRESSURE MONITORING _0288381 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


a.

Disconnect the tire pressure warning ECU and receiver K6 connector and measure the voltage or resistance on the wire harness side.

C279757C17
2.25,0.75 2.75,1 0.5,0.25 0.167,0.135 0.479,0.292 0.313,0.156 10 false *a 2.406,0.792 2.865,0.99 0.458,0.198 10 false K6
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)
- -


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
K6-1 (IG1) - K6-12 (GND) V - W-B IG power source Ignition switch ON 10 to 16 V
K6-9 (GND3) - Body ground BE - Body ground Ground Always Below 1 Ω
K6-12 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω


b.

Connect the tire pressure warning ECU and receiver K6 connector.


c.

Measure the voltage according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

HINT:

Inspect the connectors from the back side while the connectors are connected.


E129452C35
0.115,0.094 0.438,0.344 0.323,0.25 10 false *a
*a Component with harness connected
(Tire Pressure Warning ECU and Receiver)
- -


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
K6-2 (SPEED) - K6-12 (GND) G - W-B Vehicle speed signal Vehicle is running Pulse generation (see waveform 1)
K6-3 (Tc) - K6-12 (GND) R - W-B TC terminal Ignition switch ON 11 to 14 V
K6-7 (CLSW) - K6-12 (GND) P - W-B Tire pressure warning reset switch
·

Ignition switch ON

·

Tire pressure warning reset switch OFF


8 to 15 V
·

Ignition switch ON

·

Tire pressure warning reset switch ON


Below 1.5 V
K6-10 (SIL) - K6-12 (GND) Y - W-B Diagnosis tester communication line Ignition switch ON, when communication is not perfomed with a GTS 8 to 14 V


d.
E149152C04
0.115,0.052 0.427,0.208 0.313,0.156 10 false *a 2.813,1.188 3.125,1.344 0.313,0.156 10 false *b
*a Example
*b GND


Using an oscilloscope, check the waveform 1.

Waveform 1:
Item Contents
Terminal No. (Symbols) 2 (SPEED) - 12 (GND)
Tool setting 5 V/DIV, 5 ms./DIV.
Vehicle condition While driving at approximately 20 km/h (12 mph).