1.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surface.
2.REMOVE BRAKE ACTUATOR WITH BRACKET
Turn down the lock lever to disconnect the brake actuator connector from the brake actuator assembly.
Be careful not to allow brake fluid to enter the removed connector.
|
10 mm Flare Nut |
|
12 mm Flare Nut |
Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.
| *a | to front wheel LH |
| *b | to rear wheel RH |
| *c | to rear wheel LH |
| *d | to front wheel RH |
| *e | from master cylinder FL-RR |
| *f | from master cylinder FR-RL |
Place tags or marks to identify the installation locations of each brake line.
Remove the 3 bolts and brake actuator with bracket.
44510
3.REMOVE BRAKE ACTUATOR ASSEMBLY
Remove the 3 bolts and the brake actuator assembly.
44547C
4.REMOVE BRAKE ACTUATOR BRACKET SPACER
Remove the 3 brake actuator bracket spacers.
44547B
5.REMOVE BRAKE ACTUATOR BRACKET CUSHION
Remove the 3 brake actuator bracket cushions.