84986
1.INSPECT VEHICLE STABILITY CONTROL SWITCH
Check the resistance.
| *a | Component without harness connected
(Vehicle Stability Control Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (B) - 4 (L) | Switch pushed | Below 1 Ω |
| 3 (B) - 4 (L) | Switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the vehicle stability control switch.
Check that the illuminates.
Apply battery voltage to the vehicle stability control switch and check that the switch illumination illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1 (ILL+)
Battery negative (-) → Terminal 2 (ILL-) |
Illuminates |
If the result is not as specified, replace the vehicle stability control switch.