Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for LHD) › from 2016.09
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015145 BRAKE MASTER CYLINDER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Release the vacuum from booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from brake booster.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surface.


Hide 31481A 2.DISCONNECT NO. 1 CLUTCH RESERVOIR HOSE (for 2NR-VE with Manual Transmission)

a.

Slide the clip and disconnect the No. 1 clutch reservoir hose.


Hide 47201 3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.
C332254

Disengage the clamp and disconnect the brake fluid level warning switch connector.


b.
C332255

Using a union nut wrench, separate the 2 brake tubes from the brake master cylinder sub-assembly.


c.
C332256

Disengage the 2 clamps and separate the 2 brale tubes from the body.


d.
C332956

Remove the 2 nuts and remove the brake master cylinder sub-assembly.


e.

Remove the O-ring from the brake master cylinder sub-assembly.

NOTICE:
·

The brake master cylinder sub-assembly requires careful handling. Do not allow the brake master cylinder sub-assembly to receive any impact, such as from being dropped. Do not reuse a brake master cylinder sub-assembly that has been dropped.

·

Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.

·

Release the vacuum from booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from brake booster.

·

When installing the brake master cylinder sub-assembly onto the brake booster, or when removing the brake master cylinder sub-assembly from the brake booster, make sure that the brake master cylinder sub-assembly is kept horizontal or its tip faces downward (the piston faces upward) to prevent the master cylinder piston from falling off.

·

Do not allow any foreign objects to contaminate the master cylinder piston. If a foreign object gets on the piston, remove it by using a piece of cloth and then apply an even layer of lithium soap based glycol grease around the circumference (sliding part) of the piston.

·

Do not use any other type of grease or fluid.