Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING VALVE › from 2016.09
RM19Y0E _53 Suspension _059025 TIRE PRESSURE MONITORING _0288379 TIRE PRESSURE WARNING VALVE A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING VALVE  REASSEMBLY  


PROCEDURE

Hide 1.REMOVE FRONT TIRE

Hide 2.REMOVE REAR TIRE

Hide 42607 3.REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

a.

Remove the cap and valve core to release the air from the tire.

NOTICE:

Keep the removed cap.



b.

After ensuring that a sufficient amount of air has been released, remove the nut and washer used to secure the tire pressure warning valve and transmitter. Drop the tire pressure warning valve and transmitter with the grommet into the tire.

HINT:

The grommet may remain attached to the rim.



c.
C245209C01
2.656,0.917 2.406,0.917 false 0.979,1 0.729,1 false 0.531,0.917 0.844,1.073 0.313,0.156 10 false *1 2.719,0.844 3.031,1 0.313,0.156 10 false *2 2.063,1.813 2.49,2.021 0.427,0.208 10 false (A)
*1 Tire
*2 Shoe


After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover.

NOTICE:
·

Be careful not to damage the tire pressure warning valve and transmitter due to interference between the valve and the tire bead.

·

Set the tire remover shoe as shown in the illustration.

Width (A):

10 to 20 mm (0.394 to 0.787 in.)





d.

Separate the upper bead.


e.

Take out the tire pressure warning valve and transmitter with the grommet from the tire and separate the lower bead.


f.

Remove the inner grommet from the tire pressure warning valve and transmitter.