Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH(for LHD) › from 2016.09
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0288643 VSC OFF SWITCH(for LHD) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH(for LHD)  INSPECTION  


PROCEDURE

Hide 84986 1.INSPECT VEHICLE STABILITY CONTROL SWITCH

a.

Check the resistance.

i.
C363898C01
1.5,1.917 1.667,1.25 true 1.25,1.917 1.5,1.25 true 1.917,1.917 1.833,1.25 true 2.167,1.917 2,1.25 true 0.135,0.146 0.448,0.302 0.313,0.156 10 false *a 1.854,1.948 2.167,2.104 0.313,0.156 10 false ILL- 2.208,1.948 2.521,2.104 0.313,0.156 10 false L 1.406,1.948 1.719,2.104 0.313,0.156 10 false ILL+ 1.177,1.948 1.49,2.104 0.313,0.156 10 false B
*a Component without harness connected
(Vehicle Stability Control Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (B) - 3 (L) Switch pushed Below 1 Ω
6 (B) - 3 (L) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the vehicle stability control switch.



b.

Check that the illuminates.

i.

Apply battery voltage to the vehicle stability control switch and check that the switch illumination illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
Illuminates


If the result is not as specified, replace the vehicle stability control switch.