84162A
1.INSPECT REAR FOG LIGHT SWITCH
| *a | Component without harness connected
(Rear Fog Light Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (+) - 4 (-) | Rear fog light switch off | 10 kΩ or higher |
| Rear fog light switch on | Below 1 Ω |
If the result is not as specified, there may be a malfunction in the rear fog light switch.
Apply battery voltage to the connector and check the LED illumination condition.
| Battery Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1 (ILL+)
Battery negative (-) → Terminal 2 (ILL-) |
LED illuminates |
If the result is not as specified, there may be a malfunction in the rear fog light switch.