Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RESET SWITCH › from 2016.09
RM19Y0E _53 Suspension _059025 TIRE PRESSURE MONITORING _0290434 TIRE PRESSURE WARNING RESET SWITCH G

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RESET SWITCH  INSPECTION  


PROCEDURE

Hide 84746 1.INSPECT TIRE PRESSURE WARNING SWITCH

a.

Check the resistance.

i.
C363902C01
1.385,1.896 1.469,1.479 true 2.167,1.896 2,1.479 true 0.167,0.177 0.479,0.333 0.313,0.156 10 false *a 2.188,1.917 2.635,2.104 0.448,0.188 10 false CL- 1.25,1.927 1.635,2.115 0.385,0.188 10 false CL+
*a Component without harness connected
(Tire Pressure Warning Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (CL+) - 1 (CL-) Switch pushed Below 1 Ω
4 (CL+) - 1 (CL-) Switch not pushed 10 kΩ or higher


If the result is bnot as specified, replace tire pressure warning switch.