Home › Vehicle Exterior › BODY PANEL › QUARTER PANEL EXTENSION
BM32K0E _01 Vehicle Exterior _060428 BODY WELD POINT _0296454 QUARTER PANEL EXTENSION F

BODY WELD POINT  QUARTER PANEL EXTENSION  CUT AND JOIN REPLACEMENT SECTIONS  


K137822

With the back door opening trough assembly removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108826

Cut with Disc Sander etc.
K108827

Cut and Join Location

K137678C02
3.99,0.729 4.302,0.885 0.313,0.156 10 false *a
*a 50 mm (1.97 in.) - -



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108827

Cut and Join Location
K108831

Butt Weld

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

If the entire supply part is not needed, remove the part of the supply part that is needed.

K137682C01
2.688,3.042 2.906,3.042 2.906,3.042 3.771,2.552 false 2.5,2.927 2.813,3.083 0.313,0.156 10 false *1 4.271,1.417 4.583,1.573 0.313,0.156 10 false *a
*1 BACK DOOR OPENING SIDE FRAME UPPER - -
*a 50 mm (1.9685 in.) - -



c.

Before temporarily installing the new parts, weld the back door opening side frame upper and back door side stopper retainer with the standard number of welding points.

K137806C01
2.573,1.677 2.771,1.677 2.771,1.677 4.031,1.927 false 4.792,0.896 4.594,0.896 4.594,0.896 3.875,1.417 false 4.854,0.781 5.167,0.938 0.313,0.156 10 false *1 2.385,1.563 2.698,1.719 0.313,0.156 10 false *2
*1 BACK DOOR OPENING SIDE FRAME UPPER *2 BACK DOOR SIDE STOPPER RETAINER



d.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

K137679


e.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


f.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.