Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM
NM32K0E _54 Brake _061056 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0299072 BRAKE CONTROL SYSTEM DE DETAILS F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  DETAILS  SPEED SENSOR  


CONSTRUCTION


a.

Active type speed sensors that can measure down to a very low speed are used.


b.

The front speed sensors are installed to the steering knuckle. The front speed sensors use a magnetic sensor rotor which consists of N and S poles that are arranged in a circle. The rotors of the front speed sensors are mounted to the inner race of the front axle hub and bearing assemblies.


c.

The rear speed sensors which are integrated into the hub are installed to the edge of the outer race of the rear axle hub and bearing assemblies. The rear speed sensors use a magnetic sensor rotor which consists of N and S poles that are arranged in a circle. The rear speed sensor rotors are mounted to the inner race of the rear axle hub and bearing assemblies.

Front Speed Sensor
X130815C01
1.271,0.271 1.5,0.271 1.5,0.271 1.938,0.719 true 4.729,0.844 5.313,0.844 true 5.771,1.552 6.115,1.552 true 1.073,0.198 1.385,0.354 0.313,0.156 10 false *1 6.177,1.479 6.49,1.635 0.313,0.156 10 false *2 4.521,0.76 4.833,0.917 0.313,0.156 10 false *1
*1 Speed Sensor *2 Sensor Rotor


Rear Speed Sensor
X130816C01
0.99,1.177 1.563,1.177 true 5.719,1.385 6.292,1.385 true 0.792,1.094 1.104,1.25 0.313,0.156 10 false *1 6.354,1.302 6.667,1.458 0.313,0.156 10 false *2
*1 Speed Sensor *2 Sensor Rotor



d.

System Control

i.

The magnetic rotor consists of 48 ferrite powder magnets embedded around its circumference.


ii.

The active type speed sensor uses a sensor IC to detect the changes in the magnetic field as the sensor rotor rotates, and outputs a pulse signal representing the rotational speed of the wheel.


iii.

The frequency of the pulses is used to determine the speed of the vehicle and detection down to almost 0 km/h is possible.

X112177E09
2.615,1.229 2.844,1.229 true 4.823,2.094 4.99,2.094 4.99,2.094 5.104,3.031 true 0.448,1.146 2.583,1.792 2.135,0.646 10 false Magnetic rotor consists of N and S poles that are arranged in an alternating sequence 4.333,1.594 6.625,1.854 2.292,0.26 10 false Speed sensor with sensor IC 1.271,2.01 4.771,2.604 3.5,0.594 10 false The sensor cannot detect vehicle speed unless the actual vehicle speed exceeds a threshold. 0.594,2.771 1.021,3.188 0.427,0.417 10 false Wheel speed 6.177,3.76 6.969,4.021 0.792,0.26 10 false Threshold 1.115,4.375 3.385,4.656 2.271,0.281 10 false Active type speed sensor 4.417,4.385 6.313,4.656 1.896,0.271 10 false Passive type speed sensor 0.583,3.792 1.031,4.208 0.448,0.417 10 false Output pulse 3.698,2.771 4.125,3.188 0.427,0.417 10 false Wheel speed 3.677,3.833 4.125,4.25 0.448,0.417 10 false Output pulse