Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM (for NICKEL METAL HYDRIDE BATTERY) › from 2019.09
NM32K0E _51 Engine / Hybrid System _059761 HYBRID / BATTERY CONTROL _0407472 HYBRID BATTERY SYSTEM(for NICKEL METAL HYDRIDE BATTERY) DE DETAILS F

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM(for NICKEL METAL HYDRIDE BATTERY)  DETAILS  HV BATTERY JUNCTION BLOCK  


CONSTRUCTION


a.

The HV battery junction block assembly consists of the System Main Relays (SMRs), precharge resistor and battery current sensor.


b.

The SMRs are relays that connect and disconnect the HV battery and power cable (HV floor under wire) in accordance with the signal from the hybrid vehicle control ECU. 3 relays are provided; SMRB for the battery positive (+) side, SMRG for the battery negative (-) side, and SMRP for pre-charging.

W139229C02
0.833,2.333 1,2.333 1,2.333 1.25,1.917 true 2,1.333 2.167,1.083 2.167,1.083 2.333,1.083 true 2.667,1.75 2.833,1.5 2.833,1.5 3,1.5 true 3,2.083 3.167,1.833 3.167,1.833 3.333,1.833 true 2.417,1.583 2.583,1.333 2.583,1.333 2.75,1.333 true 0.521,0.667 0.833,0.823 0.313,0.156 10 false *1 2.354,1 2.667,1.156 0.313,0.156 10 false *2 2.771,1.25 3.083,1.406 0.313,0.156 10 false *3 3.031,1.417 3.344,1.573 0.313,0.156 10 false *4 3.365,1.75 3.677,1.906 0.313,0.156 10 false *5 0.656,2.25 0.969,2.406 0.313,0.156 10 false *6 0.229,6.531 0.542,6.688 0.313,0.156 10 false *a
*1 HV Battery Junction Block Assembly *2 SMRB
*3 SMRP *4 SMRG
*5 Precharge Resistor *6 Battery Current Sensor
*a The illustrations shown are examples only. - -



c.

A battery current sensor, which is built into the HV battery junction block assembly, is used to detect the HV battery charging and discharging amperage.


d.

The hybrid vehicle control ECU optimally controls the hybrid system so that the SOC of the HV battery can always be within a specified range according to the amperage information that is received via the battery smart unit (battery voltage sensor).