Home › Engine / Hybrid System › M20A-FXS (COOLING) › COOLANT FLOW › from 2019.09
NM32K0E _51 Engine / Hybrid System _084577 M20A-FXS COOLING _0407537 COOLANT FLOW GE GENERAL F

M20A-FXS COOLING  COOLANT FLOW  GENERAL  GENERAL  


OUTLINE


a.

The cooling system uses a pressurized forced circulation system with pressurized reservoir tank.


b.

An electric engine water pump is used to reduce friction losses and weight.


c.

A thermostat is located on the water inlet housing to maintain suitable temperature distribution in the cooling system.


d.

An early warm up system for the cylinder block sub-assembly is used for enhancing fuel economy. By controlling the flow shutting valve in order to open or close coolant passages, warming/cooling for each device can be prioritized.


e.

An aluminum radiator core is used for weight reduction.


f.

TOYOTA genuine Super Long Life Coolant (SLLC) is used.



SPECIFICATION


a.

Engine Coolant

i.

TOYOTA genuine Super Long Life Coolant (SLLC) is used. The maintenance interval is as shown in the table below:

Coolant Type TOYOTA Genuine SLLC or the Following
Maintenance Intervals First Time 160000 km (100000 miles)
Subsequent Every 80000 km (50000 miles)
Color Pink

HINT:

Similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non borate coolant with long-life hybrid organic acid technology. (Coolant with long-life hybrid organic acid technology consists of a combination of low phosphates and organic acids.)



ii.

SLLC is pre-mixed (50% coolant and 50% deionized water), and therefore does not need to be diluted.



b.

Thermostat

Thermostat Opening Temperature 80 to 84°C (176 to 183°F)