FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
| Headlight ECU Sub-assembly LH/RH | Receives various signals, calculates the target lighting angle, and actuates the headlight swivel motor LH/RH. |
| Headlight Swivel Motor LH/RH | ·
Driven by the headlight ECU Sub-assembly LH/RH and the headlight swivel motor moves the low beam to vary its angle calculated by the headlight ECU Sub-assembly. ·
Driven by the headlight ECU Sub-assembly LH/RH and the headlight swivel motor moves the low beam left or right to the angle calculated by the headlight ECU sub-assembly. |
| Steering Sensor | Outputs the steering angle. |
| Main Body ECU (Multiplex Network Body ECU) | Receives a HEAD position signal from the light control switch and transmits it to the headlight ECU sub-assembly. |
| Brake Actuator Assembly
·
Skid Control ECU |
Receives speed sensor signals and transmits it to the headlight ECU sub-assembly. |
| Headlight Dimmer Switch Assembly
·
Light Control Switch |
Transmits a HEAD position signal to the main body ECU (multiplex network body ECU). |
| Hybrid Vehicle Control ECU | Transmits the shift position signals to the headlight ECU sub-assembly. |
| Combination Meter Assembly | Displays a warning message when a malfunction is detected in the intelligent adaptive front-lighting system (AFS). |
SYSTEM CONTROL
Low Speed Control
The headlight ECU sub-assembly LH performs low speed control when all of the following conditions are met:
Hybrid system is READY.
Vehicle is moving forward at a speed of 10 km/h (6 mph) or more.
Vehicle is moving forward at a speed of less than 30 km/h (19 mph).
Steering angle is 6° or more.
Low beam headlights are on.
| Driving Condition | Low Beam | |
|---|---|---|
| Left | Right | |
| Right Turn | 0° Fixed | 0° to 15° to Right |
| Left Turn | 0° to 10° to Left | 0° Fixed |
Medium-to-High Speed Control
The headlight ECU sub-assembly LH performs medium-to-high speed control when all of the following conditions are met:
Hybrid system is READY.
Vehicle is moving forward at a speed of 30 km/h (19 mph) or more.
Steering angle is 7.5° or more.
Low beam headlights are on.
| Driving Condition | Low Beam | |
|---|---|---|
| Left | Right | |
| Right Turn | 0° to 5° to Right | 0° to 15° to Right |
| Left Turn | 0° to 10° to Left | 0° to 7.5° to Left |
Operation Stop Condition
The headlight ECU sub-assembly LH stops performing control when any of the following conditions is met:
Hybrid system is off.
Vehicle is moving forward at a speed of less than 5 km/h (3 mph).
Steering angle is less than 7.5°.
Low beam headlights are off.
Shift lever in R or N.
DIAGNOSIS
When the headlight ECU sub-assembly detects a malfunction in the intelligent adaptive front-lighting system (AFS), Diagnostic Trouble Codes (DTCs) are stored in memory.
The DTCs can be read using the Global TechStream (GTS). For details, refer to the Repair Manual.