Home › Vehicle Exterior › ACOUSTIC VEHICLE ALERTING SYSTEM › ACOUSTIC VEHICLE ALERTING SYSTEM › from 2020.08
NM32K0E _59 Vehicle Exterior _094127 ACOUSTIC VEHICLE ALERTING SYSTEM _0443301 ACOUSTIC VEHICLE ALERTING SYSTEM CO CONTROL F

ACOUSTIC VEHICLE ALERTING SYSTEM  ACOUSTIC VEHICLE ALERTING SYSTEM  CONTROL  ACOUSTIC VEHICLE ALERTING CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Vehicle Approaching Speaker Controller Controls starting and stopping of operation, sound pitch and volume level based on signals received from the hybrid vehicle control ECU and skid control ECU.
Vehicle Approaching Speaker Assembly Emits warning sounds based on the operation signal received from the vehicle approaching speaker controller.
Hybrid Vehicle Control ECU
·

Outputs a shift position signal, stop light switch signal and front motor speed signal to the vehicle approaching speaker controller.

·

Sends a permission signal to the vehicle approaching speaker controller.


Combination Meter Assembly
·

Multi-information Display


Displays a warning message when there is a malfunction in the vehicle proximity notification system.
Brake Booster with Master Cylinder Assembly
·

Skid Control ECU


Outputs a vehicle speed signal to the vehicle approaching speaker controller.
Central Gateway ECU (Network Gateway ECU) Relays data between buses.


OPERATING CONDITION


Condition Outline
System Active The vehicle proximity notification system operates (emits a warning sound) when either of the following conditions is met:
·

The vehicle speed is 0 km/h (0 mph), the engine is stopped, the stop light is turned off and the shift position is other than P.*

·

The vehicle speed is 25 km/h (15 mph) or less, the engine is stopped and the shift position is other than P.


System Stop The vehicle proximity notification system stops operating when any of the following conditions is met:
·

The shift position is P.

·

The engine starts.

·

The vehicle speed is more than 25 km/h (15 mph).

·

With a vehicle speed of 0 km/h (0 mph), the stop light on signal is received continuously for more than approximately 1 second.

·

With a vehicle speed of 0 km/h (0 mph), the stop light off signal is received continuously for more than approximately 3 seconds (such as when the vehicle is stopped, and in neutral with the parking brake applied).



HINT:

*: When the system is stopped due to a vehicle speed of 0 km/h (0 mph) and the stop light switch off signal is received continuously for more than approximately 3 seconds, the system operates again when any of the following conditions is met:

- A vehicle speed signal of 1 km/h (1 mph) or more is received.

- The brake pedal is operated.




SYSTEM CONTROL


Control Outline
Vehicle Speed Linked Control
·

Emits the warning sound by controlling the pitch of the sound in accordance with the vehicle speed.

·

The warning sound becomes higher as the vehicle accelerates and it becomes lower as the vehicle decelerates.


Fade-in/Fade Out Control When the system starts operating, the warning sound volume gradually increases, and when system operation is stopped, the sound volume gradually decreases.
Control during Reverse Operation When the vehicle is being driven in reverse, the warning sound volume becomes higher than it is when driving forward so that the sound is easy to hear even while reversing.


FUNCTION


a.

Warning Indication

i.

The combination meter assembly uses the multi-information display to notify the driver of acoustic vehicle alerting system malfunctions.


ii.

When the system is not available, the following warning occurs to warn the driver.

When a system malfunction is detected
Multi-information Display Detail Buzzer DTC
Acoustic Vehicle Alerting System Malfunction. Visit your Dealer. This message appears when the vehicle approaching speaker controller detects a system malfunction Sounds once Repair is required DTCs are stored




DIAGNOSIS


a.

The vehicle approaching speaker controller will also store Diagnostic Trouble Codes (DTCs). The DTCs can be read by using the GTS. For details, refer to the Repair Manual.