FUNCTION
Rear Seat Belt Warning
The rear seat belt warning function indicates the state of the rear seat belts using the clock assembly.
The combination meter assembly sends a rear seat belt warning signal to the clock assembly based on the rear seat belt buckle switches and courtesy switches for the rear doors. When the signal is received, the clock assembly operates the lights. If a warning is necessary, the buzzer in the combination meter assembly will also sound.
The flow of operations that results in a rear seat belt warning is as follows:
| Step | Condition Transition | Warning Light | Buzzer |
|---|---|---|---|
| (a) | Power switch is off. | Warning is not displayed. | No Sound |
| (b) | ·
Power switch is turned on (IG). ·
A seat belt is fastened. |
·
In this case, all seats will be displayed as being unfastened regardless of the number of occupants. ·
The warning light comes on for a certain period of time. ·
If seat belts are then fastened, the display for the relevant seat will go off. |
|
| (c) | Any of the rear seat belts are unfastened. | Seats with an unfastened seat belt will be displayed regardless of the number of occupants. | When the vehicle speed exceeds 20 km/h (12 mph), it will sound for a certain period of time. |
| (d) | When one of the following conditions is met, the buzzer will stop sounding.
- The seat belt is refastened. - Vehicle speed is lower than approximately 2 km/h (1.2 mph) and either the parking brake is applied or the shift lever is in P. |
·
Seats with an unfastened seat belt will be displayed regardless of the number of occupants. ·
The warning light comes on for a certain period of time. ·
If seat belts are then fastened, the display for the relevant seat will go off. |
Stops sounding |