Home › Engine / Hybrid System › 2ZR-FXE (ENGINE MECHANICAL) › ENGINE UNIT › from 2020.08
NM32K0E _51 Engine / Hybrid System _061022 2ZR-FXE ENGINE MECHANICAL _0299032 ENGINE UNIT GE GENERAL F

2ZR-FXE ENGINE MECHANICAL  ENGINE UNIT  GENERAL  GENERAL  


OUTLINE


a.

The 2ZR-FXE engine is an in-line, 4-cylinder, 1.8-liter, 16-valve DOHC engine.


b.

This engine uses a high-expansion ratio Atkinson cycle, Variable Valve Timing-intelligent (VVT-i) system, Direct Ignition System (DIS), Electronic Throttle Control System-intelligent (ETCS-i) and Exhaust Gas Recirculation (EGR) system employing a highly efficient EGR cooler. In addition, use of an electric water pump has enhanced warm-up performance and reduced cooling losses. Thus, improved engine performance, quietness, fuel economy, and cleaner emissions have been achieved.



SPECIFICATION


Item Specification

*: Emission regulations differ depending on the specifications of the vehicle.

Engine Type 2ZR-FXE
No. of Cyls. & Arrangement 4-cylinder, In-line
Valve Mechanism 16 valve DOHC, Chain Drive
(with VVT-i)
Combustion Chamber Pentroof Type
Flow of Intake and Exhaust Gasses Cross-flow
Fuel System Sequential Multiport Fuel Injection (SFI)
Ignition System Direct Ignition System (DIS)
Displacement cm3 (cu. in.) 1798 (109.7)
Bore x Stroke mm (in.) 80.5 X 88.3 (3.17 X 3.48)
Compression Ratio 13.0 : 1
Max. Output (EEC) kW@rpm 72@5200
Max. Torque (EEC) N*m@rpm 142@3600
Valve Timing Intake Open 40° BTDC to 22° ATDC
Close 40° ABDC to 102° ABDC
Exhaust Open 35° BBDC
Close 9° ATDC
Spark Plug Type DENSO Made FC16HR-CY9 (Iridium)
Plug Gap mm (in.) 0.8 to 0.9 (0.0315 to 0.0354)
Firing Order 1 - 3 - 4 - 2
Research Octane Number Models with Dual-passage Cooling System 95 or higher
Models without Dual-passage Cooling System 91 or higher
Octane Rating Models with Dual-passage Cooling System 91 or higher
Models without Dual-passage Cooling System 87 or higher
Emission Regulation* EURO 6, EURO 6d


MAIN FEATURES


a.

The 2ZR-FXE engine has achieved the following through the use of the items listed in the table below.

(A): High performance and reliability

(B): Low noise and vibration

(C): Lightweight and compact design

(D): Good serviceability

(E): Clean emissions and fuel economy

Item (A) (B) (C) (D) (E)

*: Models with dual-passage cooling system

The high-expansion ratio Atkinson cycle is adopted. - - - - ○
Engine Proper An aluminum cylinder block sub-assembly is used. - - ○ - -
An offset crankshaft is used. ○ ○ - - ○
Spiny type liners are used. ○ - - - ○
Drilled V-shaped passages in the cylinder block sub-assembly are used. ○ - - - ○
The tumble keep shape is used for the top of the pistons. ○ - - - ○
The skirt portion of the piston has a resin coating applied to reduce friction. ○ ○ - - ○
Valve Mechanism A chain sub-assembly and No. 1 chain tensioner assembly are used. - ○ - ○ -
Valve lash adjuster assemblies are used. - ○ - ○ -
No. 1 valve rocker arm sub-assemblies are used. - ○ - - ○
The Variable Valve Timing-intelligent (VVT-i) system is used. ○ - - - ○
Intake and Exhaust System A plastic intake manifold is used. - - ○ - -
A linkless type throttle body assembly is used. - - ○ ○ -
A step motor type Exhaust Gas Recirculation (EGR) valve is used. ○ - - - ○
A water-cooled type Exhaust Gas Recirculation (EGR) cooler is used. ○ - - - ○
A stainless steel exhaust manifold is used. - - ○ - ○
Three-Way Catalytic converters (TWCs) are used. - - - - ○
A 2-way exhaust control system is used. ○ ○ - - -
Fuel System 12-hole type fuel injector assemblies are used. ○ - - - ○
A fuel returnless system is used. - - ○ ○ -
Quick connectors are used to connect the fuel hoses and fuel pipes. - - - ○ -
Cooling System An electric engine water pump assembly is used. - - - - ○
A dual-passage cooling system is used.* ○ - - - ○
Ignition System A Direct Ignition System (DIS) is used. ○ - ○ ○ ○
Long-reach type iridium-tipped spark plugs are used. ○ - - ○ ○
Engine Control System The Electronic Throttle Control System-intelligent (ETCS-i) is used. ○ - - - ○
A Magneto-Resistance Element (MRE) type cam position sensor is used. ○ - - - -
A flat type knock control sensor is used. ○ - - - -

HINT:

○: Applicable

-: Not applicable