Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › MOTOR GENERATOR CONTROL SYSTEM › 2016.10–2018.05
RM32K0E _51 Engine / Hybrid System _059620 HYBRID / BATTERY CONTROL _0292487 MOTOR GENERATOR CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  MOTOR GENERATOR CONTROL SYSTEM  P0C3811  DC/DC Converter Temperature Sensor "A" Circuit Short to Ground  P0C3815  DC/DC Converter Temperature Sensor "A" Circuit Short to Battery or Open  P0C3D11  DC/DC Converter Temperature Sensor "B" Circuit Short to Ground  P0C3D15  DC/DC Converter Temperature Sensor "B" Circuit Short to Battery or Open  


DESCRIPTION

The motor generator control ECU (MG ECU) located in the inverter with converter assembly detects the temperature of the boost converter using the temperature sensor built into the boost converter. The motor generator control ECU (MG ECU) detects malfunctions in the boost converter temperature sensor and its wiring.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0C3811 DC/DC Converter Temperature Sensor "A" Circuit Short to Ground Short to ground detected in boost converter temperature sensor (upper) signal circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning Light:
Comes on
P0C3815 DC/DC Converter Temperature Sensor "A" Circuit Short to Battery or Open Open or short to +B detected in boost converter temperature sensor (upper) signal circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning Light:
Comes on
P0C3D11 DC/DC Converter Temperature Sensor "B" Circuit Short to Ground Short to ground detected in boost converter temperature sensor (lower) signal circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning Light:
Comes on
P0C3D15 DC/DC Converter Temperature Sensor "B" Circuit Short to Battery or Open Open or short to +B detected in boost converter temperature sensor (lower) signal circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning Light:
Comes on

Related Data List
DTC No. Data List
P0C3811 Boosting Converter Temperature (Upper)
P0C3815
P0C3D11 Boosting Converter Temperature 1 (Lower)
P0C3D15

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM>UTILITY


1.

Connect the GTS to the DLC3.

2.

Turn the power switch on (IG) and turn the GTS on.

3.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

4.

Turn the power switch off and wait for 2 minutes or more.

5.

Turn the power switch on (IG) and turn the GTS on.

6.

With power switch on (IG) and wait for 5 seconds or more.

7.

Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.

8.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.




PROCEDURE

1.REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS

NEXT

COMPLETED