The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during motor cable removal/installation are shown below.
*1: When performing learning using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>CALIBRATION
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PRECAUTION
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
G9200
1.REMOVE INVERTER WITH CONVERTER ASSEMBLY
G1148
2.REMOVE MOTOR CABLE
Be sure to wear insulated gloves.
Remove the 2 bolts and connector cover from the hybrid vehicle transaxle assembly.
Disengage the 2 claws to remove the terminal cap from the hybrid vehicle transaxle assembly.
| *a | Waterproof Seal |
Using an insulated tool, remove the 6 bolts and motor cable from the hybrid vehicle transaxle assembly.
Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
Do not touch the waterproof seal or terminals of the motor cable.
Cover the hole where the motor cable was installed with tape or equivalent (non-residue type) to prevent entry of foreign matter.