Home › Drivetrain › P610 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT LEVER POSITION SENSOR
RM32K0E _52 Drivetrain _059722 P610 HYBRID TRANSMISSION / TRANSAXLE _0292765 SHIFT LEVER POSITION SENSOR A

P610 HYBRID TRANSMISSION / TRANSAXLE  SHIFT LEVER POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
·
C332327

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 51441 2.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444A 3.REMOVE REAR ENGINE UNDER COVER LH

Hide 33820B 4.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C365176

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


c.

Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.


Hide 89451A 5.REMOVE SHIFT LEVER POSITION SENSOR

a.
C365177

Disconnect the shift lever position sensor connector.


b.
C365178

Remove the nut, washer and control shaft lever from the hybrid vehicle transaxle assembly.


c.
C365179C01
1.75,1.417 1.75,1.083 true 1.656,1.427 1.854,1.625 0.198,0.198 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, bend back the tabs of the lock plate.


d.
C365180C01
1.313,0.833 1.646,0.833 true 1.823,1.031 2.156,1.031 true 2.177,0.917 2.375,1.115 0.198,0.198 10 true *1 1.104,0.719 1.302,0.906 0.198,0.188 10 true *2
*1 Lock Nut
*2 Lock Plate


Remove the lock nut and lock plate from the shift lever position sensor.


e.
C365181

Remove the 2 bolts and shift lever position sensor from the hybrid vehicle transaxle assembly.


Hide 6.REMOVE SHIFT LEVER POSITION SENSOR SEAL

HINT:

Perform this procedure only when replacement of the shift lever position sensor seal is necessary.


a.
C365182C01
1.833,1.5 1.833,1.167 true 1.75,1.51 1.948,1.708 0.198,0.198 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, remove the shift lever position sensor seal from the hybrid vehicle transaxle assembly.

NOTICE:

When removing the shift lever position sensor seal, make sure not to damage the parking lock shaft or transaxle case.