89451A
1.INSPECT SHIFT LEVER POSITION SENSOR
| *a | Component without harness connected
(Shift Lever Position Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (+B) - 1 (DB1) | Shift lever in D or B | Below 1 Ω |
| Shift lever not in D and B | 10 kΩ or higher | |
| 7 (+B) - 2 (N) | Shift lever in N | Below 1 Ω |
| Shift lever not in N | 10 kΩ or higher | |
| 7 (+B) - 3 (PR) | Shift lever in P or R | Below 1 Ω |
| Shift lever not in P and R | 10 kΩ or higher | |
| 7 (+B) - 4 (PNB) | Shift lever in P, N or B | Below 1 Ω |
| Shift lever not in P, N and B | 10 kΩ or higher | |
| 7 (+B) - 6 (DB2) | Shift lever in D or B | Below 1 Ω |
| Shift lever not in D and B | 10 kΩ or higher | |
| 7 (+B) - 8 (P) | Shift lever in P | Below 1 Ω |
| Shift lever not in P | 10 kΩ or higher | |
| 7 (+B) - 9 (R) | Shift lever in R | Below 1 Ω |
| Shift lever not in R | 10 kΩ or higher |
If the result is not as specified, replace the shift lever position sensor.