Home › General › SPECIFICATIONS › HYBRID / BATTERY CONTROL › 2016.10–2019.09
RM32K0E _V1 General _059401 SPECIFICATIONS _0294119 HYBRID / BATTERY CONTROL F

SPECIFICATIONS  HYBRID / BATTERY CONTROL  SERVICE DATA  


Reserve Tank Cap (for Inverter)
Item Specified Condition
Standard Value (for Brand-new Cap) 94 to 122 kPa (1.0 to 1.2 kgf/cm2, 13.6 to 18 psi)
Minimum Standard Value (for Used Cap) 94 kPa (1.0 kgf/cm2, 13.6 psi)

Relay
Item Tester Connection Specified Condition
IGCT relay (IGCT)
Resistance
3 - 5 10 kΩ or higher
(Auxiliary battery voltage not applied between terminals 1 and 2)
Below 1 Ω
(Auxiliary battery voltage applied between terminals 1 and 2)

HV Battery Junction Block Assembly
SMRB
Resistance
T3-1 (CBI) - A-1 (+) 10 kΩ or higher
(Auxiliary battery voltage is not applied between terminals M42-1 (SMRB) and M42-3 (GND))
Below 1 Ω
(Auxiliary battery voltage applied between terminals M42-1 (SMRB) and M42-3 (GND))
M42-1 (SMRB) - M42-3 (GND) 20.6 to 40.8 Ω at -40 to 80°C (-40 to 176°F)
SMRG
Resistance
T2-1 (CEI) - z10-1 (-) 10 kΩ or higher
(Auxiliary battery voltage not applied between terminals M42-4 (SMRG) and M42-3 (GND))
Below 1 Ω
(Auxiliary battery voltage applied between terminals M42-4 (SMRG) and M42-3 (GND))
M42-4 (SMRG) - M42-3 (GND) 20.6 to 40.8 Ω at -40 to 80°C (-40 to 176°F)
SMRP
Resistance
T2-1 (CEI) - z10-1 (-) 10 kΩ or higher
(Auxiliary battery voltage applied between terminals M42-2 (SMRP) and M42-3 (GND))
24.3 to 29.7 Ω
(Auxiliary battery voltage applied between terminals M42-2 (SMRP) and M42-3 (GND))
M42-2 (SMRP) - M42-3 (GND) 140 to 290 Ω at -40 to 80°C (-40 to 176°F)

EV Drive Mode Switch (Electric Parking Brake Switch Assembly) (for LHD)
EV Drive Mode Switch (Electric Parking Brake Switch Assembly)
Resistance
11 (S) - 8 (E) Below 1 Ω
(EV drive mode switch being pushed and held)
10 kΩ or higher
(EV drive mode switch not pushed)
Auxiliary Battery positive (+) → 7 (ILL+)
Auxiliary Battery negative (-) → 1 (ILL-)
Illuminates

EV Drive Mode Switch (Electric Parking Brake Switch Assembly) (for RHD)
EV Drive Mode Switch (Electric Parking Brake Switch Assembly)
Resistance
13 (S) - 8 (E) Below 1 Ω
(EV drive mode switch being pushed and held)
10 kΩ or higher
(EV drive mode switch not pushed)
Auxiliary Battery positive (+) → 7 (ILL+)
Auxiliary Battery negative (-) → 1 (ILL-)
Illuminates

Service Plug Grip
Service plug grip - Below 1 Ω

Hybrid Battery Terminal Block
Hybrid Battery Terminal Block - Below 1 Ω