Home › Engine / Hybrid System › 2ZR-FXE (FUEL) › FUEL PUMP
RM32K0E _51 Engine / Hybrid System _060063 2ZR-FXE FUEL _0294218 FUEL PUMP G

2ZR-FXE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.
A288171C12
1.333,1.083 1.583,0.667 false 2.083,1.083 1.833,0.667 false 1.26,1.135 1.417,1.333 0.156,0.198 10 false 1 2.094,1.135 2.25,1.333 0.156,0.198 10 false 2 0.635,0.083 0.948,0.24 0.313,0.156 10 false *a
*a Component without harness connected
(Fuel Pump)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check the operation.

i.

Apply auxiliary battery voltage to both terminals. Check that the fuel pump operates.

NOTICE:
·

Perform this test within 10 seconds to prevent the coil from burning out.

·

Keep the fuel pump as far away from the auxiliary battery as possible.

·

Always switch the voltage on and off at the auxiliary battery side, not the fuel pump side.



If the fuel pump does not operate, replace the fuel pump.