Home › Engine / Hybrid System › 2ZR-FXE (FUEL) › FUEL SENDER GAUGE ASSEMBLY
RM32K0E _51 Engine / Hybrid System _060063 2ZR-FXE FUEL _0294220 FUEL SENDER GAUGE ASSEMBLY G

2ZR-FXE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

CAUTION:

Perform the inspection in a well-ventilated area.

Do not perform the inspection near an open flame.


a.

Check that the float moves smoothly between F and E.


b.

Check the fuel sender gauge assembly voltage.

i.
A315527C01
0.063,0.063 0.375,0.219 0.313,0.156 10 false *a 1.646,2.49 1.958,2.646 0.313,0.156 10 false *b
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage Applied between Terminals


Apply 5 V between terminals 2 and 3.

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 2 or 3.



HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.



ii.
A393926C01
0.083,0.083 1.667,1.417 1.583,1.333 2.719,4.417 3.052,4.417 false 2.177,2.667 2.51,2.667 false 0.125,0.125 0.438,0.323 0.313,0.198 10 false *a 2.563,2.563 2.719,2.76 0.156,0.198 10 false F 3.115,4.313 3.271,4.51 0.156,0.198 10 false E
*a Component without harness connected
(Fuel Sender Gauge Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Float Level Specified Condition
1 - 2 F 4.255 to 4.605 V*
Between F and E 0.345 to 4.605 V* (Gradually changes)
E 0.345 to 0.695 V*


*: The output voltage changes depending on the voltage applied to the terminals.

Output voltage (F) = (0.851 x Voltage applied to terminals) to (0.921 x Voltage applied to terminals)

Output voltage (E) = (0.069 x Voltage applied to terminals) to (0.139 x Voltage applied to terminals)

If the result is not as specified, replace the fuel sender gauge assembly.