Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › 2016.10–2019.09
RM32K0E _54 Brake _060044 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0294924 ELECTRONICALLY CONTROLLED BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


CHECK FOR INTERMITTENT PROBLEMS


HINT:

A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detected using the Data List function of the GTS.


a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the GTS on.


e.

Follow the directions on the GTS to display the Data List and select areas where momentary interruptions should be monitored.

HINT:
·

A momentary interruption (open circuit) cannot be detected for 3 seconds after the power switch is turned on (IG) (initial check).

·

If Error remains displayed for one of the items on the GTS, check for continuity between the ECU and the item for which Error is displayed.

·

If a momentary interruption occurs and Error is displayed on the GTS, Error will remain displayed on the GTS for 1 second after the circuit returns to normal.



Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Speed Open Front speed sensor RH open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
FL Speed Open Front speed sensor LH open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
RR Speed Open Rear speed sensor RH open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
RL Speed Open Rear speed sensor LH open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Yaw Rate Open Yaw rate sensor open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Deceleration Open Acceleration sensor open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Steering Open Steering angle sensor open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Stroke Open Brake pedal stroke sensor assembly open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Stroke2 Open Brake pedal stroke sensor assembly 2 open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Accumulator Open Accumulator pressure sensor open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
HV Communication Open Hybrid vehicle communication open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
FR Speed Sensor Voltage Open Front speed sensor RH voltage open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
FL Speed Sensor Voltage Open Front speed sensor LH voltage open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
RR Speed Sensor Voltage Open Rear speed sensor RH voltage open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
RL Speed Sensor Voltage Open Rear speed sensor LH voltage open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Yaw Rate Sensor Voltage Open Yaw rate sensor voltage open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Reaction Force Pressure Sensor Open Reaction force pressure sensor open detection Error or Normal Error: Momentary interruption
Normal: Normal
-
Servo Pressure Sensor Open Servo pressure sensor open detection Error or Normal Error: Momentary interruption
Normal: Normal
-

f.

While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors, or between ECUs.

OK:

Normal is displayed.


HINT:

If the display changes, this indicates that there has been a momentary interruption (open circuit) in the connector and/or wire harness. In this case, repair or replace the connectors and/or wire harnesses as one of them is faulty.